Forum > Accent
Lampka check
e-gen:
Podaj kod błędu/błędów.
Paweln:
Jedyny kod jaki pokazał komputer to zdaje się PO117 bodajże. Wiem, że to ECT sensor (Engine Coolant Temperature)- taką diagnozę podał komputer. Nie wiem co to za sprzęt testujący był. Próbowałem resetować błąd samodzielnie,przez zdjęcie klemy akumulatora i komputerowo u mechanika. Błąd wraca. Wiatrak chłodnicy chodzi chaotycznie... w cały świat.
Może sensor, który zakupiłem, też był wadliwy!
Nie wiem
Przesrane!!!
e-gen:
Czujnik temperatury cieczy chłodzącej łatwo sprawdzisz omomierzem;
Wzorcowa rezystencja czujnika temperatury cieczy chłodzącej silnika:
Temperatura cieczy °C Oporność (kΩ)
-30 <====> 22.22 ~ 31.78
-10 <====> 8.16 ~ 10.74
0 <====> 5.18 ~ 6.60
20 <====> 2.27 ~ 2.73
40 <====> 1.059 ~ 1.281
60 <====> 0.538 ~ 0.650
80 <====> 0.298 ~ 0.322
90 <====> 0.219 ~ 0.243
P0117 to Engine Coolant Temperature Circuit Low Input
The Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor whose resistance changes with the temperature. The electrical resistance of the ECTS decreases as the temperature increases, and increases as the temperature decreases. The reference 5 V in the ECM is supplied to the ECTS via a resistor in the ECM. That is, the resistor in the ECM and the thermistor in the ECTS are connected in series. When the resistance value of the thermistor in the ECTS changes according to the engine coolant temperature, the output voltage also changes.
During cold engine operation the ECM increases the fuel injection duration and controls the ignition timing using the information of engine coolant temperature to avoid engine stalling and improve drivability.
Paweln:
Jeśli : is "located in the engine coolant passage of the cylinder head" rozumieć jako sensor przy termostacie, to go wymieniłem.
Ale dzięki za info.
Podejrzewam, że to problem z przewodami albo kupiłem wadliwy sensor.
e-gen:
Mnie zastanawia ten fragment:
"The reference 5 V in the ECM is supplied to the ECTS via a resistor in the ECM. That is, the resistor in the ECM and the thermistor in the ECTS are connected in series.".
Nawigacja
[#] Następna strona